|
PRECISE AND EFFICIENT
VENTOBACCO CURING CONTROL
· Ventobacco V2K is a CURING CONTROL of
the latest technology designed to precisely control Burner's
operation during the Curing cycle. It can operate on any barn
and retrofit Heat Exchanger supplied with 120 or 220 Volts
A.C.
It is built in a plastic casing ~6" x 3" x 3"
deep and delivered with a steel mounting bracket to use in
case of absence of appropriate electrical box.
It can be mounted :
a) without the bracket on any Electrical box of appropriate
size (cutting a hole 5 ?" x 2 ?" on its front) or
b) with the bracket, on the front or on top of barn's electrical
panel or directly on a barn's sidewall protected from rain,
water drops from condensation and vibrations.
Ventobacco V2K displays continuously :
· The Dry Bulb temp. set (limit) that the Operator
sets.
· The Actual Dry Bulb temp. reading at the lower and
upper barn's part, (before and after the tobacco) where the
two sensors are positioned.
· The Temperature Advance (TA) in o F per hour that
the Operator sets.
· By pressing see float Operator can also see where
is the "floating" temperature at that moment.
"Floating" temp. is the D.B. temperature that V2K
has automatically set at that moment, as D.B. temp. advances
to reach the D.B. set limit.
How V2K operates
TO START a new Curing Cycle
· Press and keep pressed START button for about 10
sec till you see "New float……" on the
display.
(You will first see Display showing "START NEW PRG. 10",
then 9", 8" etc. till "New float ……")
appears.
Now your V2K control has got the order to START (i.e. "floating"
temperature has been adjusted to the actual barn's D.B. temperature
where from it will start increasing at the set Temperature
Advance rate to reach the D.B. set Limit).
· Press SET button once.
D.B. set limit will start blinking.
Now you can set your D.B. temp. where you want it to go
(i.e. 100 o F) by pressing + to increase - to decrease the
value.
· Press SET button again.
Temp. Advance will start blinking.
Now you can set the Temperature Advance (i.e. 1 o F/hr)
After 5 sec without pressing any button D.B. set limit and
or T.A. displays will stop blinking.
The displays now will show operator's settings on D.B. set
limit & T.A. and the actual temperatures in the barn.
- Dry Bulb set limit (i.e. 100 o F) set by operator
- Dry Bulb lower temp. (i.e. 87 o F) actual in the barn
- Dry Bulb upper temp. (i.e. 84 o F) actual in the barn
- Temperature Advance (i.e. 1 o F/hr) set by operator.
More details on V2K Curing Control
· By pressing see float button, Operator's can see
where the "Floating" D.B. temp. is set
automatically by the control at the precise moment.
If you want to increase or decrease the "floating"
temperature, you can do so by pressing button + or - while
you keep pressed see float button.
[pg.1]
[pg.2]
|
